Disponibile dal: 0000-00-00
60-Amp Pro Switch-Mode BEC Brushless ESC (V2) by E-flite Product Description Key Features Up to 60 amps continuous current with proper air flow and 75 amps burst current (15 seconds) 5A continuous current, 5V switch-mode BEC circuit (proper cooling and airflow required) Stronger BEC for support of most 3-axis stabilization systems Drive up to 7 analog or 6 digital standard-sized servos with the BEC on any recommended input voltage 3- to 6-cell Li-Po, 9- to 18-cell Ni-MH/Ni-Cd input voltage Finned heat sinks Programmable motor braking Safe power-arm mode prevents accidental starts Programmable low voltage cutoff with settings for 3-cell Li-Po (9V), 4-cell Li-Po (12V), 5-cell Li-Po (15V), 6-cell Li-Po (18V) or 74% of battery starting voltage Programmable throttle input range (1.1ms–1.9ms or 1.2ms–1.8ms) Programmable soft start for helis and airplanes Auto motor shut down if signal is lost or there is interference Programmable timing—5 user-selectable ranges for use with a large variety of brushless motors Utilizes new smaller MOSFET technology to minimize weight Radio system power on/off switch Pre-wired connectors—E-flite® EC3™ connector on battery input and 3.5mm gold bullet connectors on motor output leads Overview The E-flite® 60-Amp Pro Switch-Mode BEC Brushless ESC (V2). This is a high-quality sensorless brushless electronic speed control with an integrated switch-mode BEC that is very lightweight and efficient. It can operate without the need for a separate receiver battery to power your servos and receivers, saving you weight and complication.
No customer comments for the moment.